Beecher’s Stamp

Originally posted on MadMatMax:
Here is a custom stamp I did for Beecher’s Magazine at the University of Kansas. This was created from a jpeg file. I used Inkscape to do the tracing of the image. I saved this file…

5/16” Paper Cutter

Originally posted on MadMatMax:
I made a custom paper cutter for a student competition where they need uniform strips of paper and they need a lot of them quickly. I designed this in 123D Design using net dimensions for the…

3d Printed Puch E50 Water Cooled Head

Originally posted on MadMatMax:
I drew up a Water Cooled Puch E50 head in 123d Design. I printed it out with a 3d printer with low infill. This will allow it to be flask casted with aluminum. The holes were…

3d Printed Punch and Die Set for 2mm and 4mm spheres

3d Printed punch and die set for 2mm and 4mm spheres for compressible powder. Designed by me. The punches and dies slide inside a hole that was drilled just slightly oversize in a 2″ steel rod. Unfortunately, the die was